View Here : Xj Cut And Fold Rear Bumper
Jeep Cherokee 1984-2001: How to Cut and Fold Rear Fenders. Here are methods to use for replacing the rear bumper and back wheel rim on your Cherokee.
Made out of 1/8 inch material. These are designed to cut the factory rear lower quarter panels out. Instead of doing the traditional "cut and fold".
Our all new Mojave series Jeep Cherokee XJ Cut and Fold rear bumper is completely redesigned from the ground up. We start our new design using a sheet of tough 3/16 steel from the finest steel mills in the U.S.
DirtBound Inc. 31445 Oasis Rd Center City, MN 55012. Shop Hours: Monday-Friday 9:00am-6:00pm CST Closed Weekends & Holidays. Newsletter
Fairly common once the engine is hot. Tere's a TSB for a dealer heatshield for the #3 injector to fix the problem.
js44) Aftermarket dual-tip SEAL PULLER.Our large HCP9801 style puller features curved dual tips on a rounded head allows you to "lever out" large, thick rubber seals safely and properly, while the smaller HCP9961 puller works better with smaller seals (such as on your shifter side cover).
"When in doubt... Floor it" 1989 XJ 4.0L I6 - To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
I installed these over the past few days. IMHO these are a much better product for an XJ when compared to the standard cut-out flare. My installation was time consuming because I did it at the same time as rear quarter armor to cover a ginormous dent on the rear passenger quarter.
recall id#06v289000 - engine and engine cooling consequence: if the damper comes loose, a fuel leak may result. fuel leakage, in the presence of an ignition source, could result in a fire.
recall id#11v245000 - air bags:side/window consequence: inadvertent activation of the csa and/or the seat belt pretensioner can cause injury to a vehicle occupant.